Related Manuals for Toro 72201
Summary of Contents for Toro 72201
- Page 1 Form No. 3328–112 417XT and 419XT Wheel Horse Garden Tractor Model No. 72201—Serial No. 230000001 and Up Model No. 72202—Serial No. 230000001 and Up Operator’s Manual Domestic English (EN)
-
Page 2: Table Of Contents
Test Driving the Tractor ....Thank you for purchasing a Toro product. Checking the Safety System .... -
Page 3: Safety
All of us at Toro want you to be completely satisfied with Caution signals a hazard that may cause minor or your new product, so feel free to contact your local moderate injury if the recommended precautions are not Authorized Service Dealer for help with service, genuine followed. - Page 4 Do not smoke. have to stop or shift while on the slope. – Never refuel the machine indoors. Follow Toro’s recommendations for wheel weight or – Never store the machine or fuel container inside counterweights to improve stability. where there is an open flame, such as near a water Use extra care with grass catchers or other heater or furnace.
-
Page 5: Toro Riding Mower Safety
Avoid turning on slopes. If you must turn, turn slowly Use only genuine Toro replacement parts to ensure that and gradually downhill, if possible. original standards are maintained. Do not use a grass catcher on steep slopes. Heavy... -
Page 7: Slope Chart
Slope Chart... -
Page 9: Safety And Instruction Decals
Safety and Instruction Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 112168 92-6726 83-6620 99-2985 99-5339 93-0302 106-9871 (Model 72202 only) 1. - Page 10 99-8036 (Model 72201 only) 1. Mowing in reverse 3. Engine oil pressure enabled. 4. Power Take-off (PTO) 2. Battery 92-6721 104-4163 1. Explosion hazard 4. Wear eye protection 92-6720 2. No fire, open flames, or 5. Read the Operator’s smoking.
- Page 11 104-5091 1. Contains lead; do not 3. Wear eye protection; 5. Sulfuric acid can cause 7. Maximum fill line discard. explosive gases can cause blindness or severe burns. 8. Minimum fill line blindness and other injuries 2. Recycle 6. Flush eyes immediately with 9.
-
Page 12: Gasoline And Oil
Gasoline and Oil Recommended Gasoline Warning Use UNLEADED Regular Gasoline suitable for automotive use (85 pump octane minimum). Leaded Gasoline is harmful or fatal if swallowed. regular gasoline may be used if unleaded regular is not Long–term exposure to vapors can cause serious available. -
Page 13: Setup
Setup Note: Determine the left and right sides of the machine from the normal operating position. Loose Parts Note: Use the chart below to verify all parts have been shipped. Description Qty. Bolt, 1/4 x 3/4 inch Activating and installing the battery Hex Nut, 1/4 inch Use in ignition switch. -
Page 14: Checking The Engine Oil
Learn to Operate the Tractor Note: Make sure the vent caps are installed in battery. 7. Charge the battery for 1 hour at 10 amps or 2 hours at Learn how to operate the tractor. Read the Operation 5 amps. section starting on page 15. -
Page 15: Operation
Please carefully read all the safety instructions. Knowing this information could help you, your family, pets or bystanders avoid injury. Controls for Model 72201 Become familiar with all the controls (Fig. 1) before you start the engine and operate the machine. -
Page 16: Starting And Stopping The Engine
Releasing the Parking Brake 1. Push down on the brake pedal (Fig. 3). The parking brake lever should release. 2. Gradually release the brake pedal. m–6523 Figure 4 1. PTO—Off 4. Throttle lever 2. Choke–On 5. Fast 3. Choke–Off 6. Slow m–6516 Figure 3 1. -
Page 17: Operating The Power Take Off (Pto)
Operating the Power Take Off Understanding the Safety Interlock System (PTO) The safety interlock system is designed to prevent the The power take off (PTO) engages and disengages power engine from starting unless: to the electric clutch. You are sitting on the seat. While the ignition key is in run or lights position and the The brake pedal is depressed. - Page 18 Use the KeyChoice switch only if you are certain no children or other bystanders will Figure 9 enter the mowing area. 1. Operating-in-reverse light—Model 72201 Be very observant after deactivating the interlock because the sound of the engine may prevent you from noticing that a child or 4.
-
Page 19: Indicator Control Module
When the light comes on while the engine is running, Stop engine immediately and m–6518 correct the cause of low oil pressure. Figure 11 (Model 72201) Driving Forward or Backward 1. Power take off (PTO) 4. Oil pressure 2. -
Page 20: Stopping The Machine
To slow down, release the pressure on the traction control 2. Push the lift switch in the up direction to raise the pedal. attachment lift (Fig. 13). This will lift and hold the attachment in the up, or raised position. Important To avoid transmission damage, always release the parking brake before moving the traction... -
Page 21: Positioning The Seat
1208 Figure 16 1. Lights m–6531 Positioning the Tilt Steering Figure 14 Wheel 1. Lift lever 2. Button The steering wheel has four tilt locations. Position the steering wheel where you have the best control of the machine and are most comfortable. Positioning the Seat 1. -
Page 22: Pushing The Machine By Hand
Engaging the Cruise Control 1. Begin driving tractor: Refer to Driving Forward or Backward, page 19. While holding your foot steady on the traction control, push the cruise control switch (Fig. 18) to the lock–set position. M–4566 Figure 19 1. Operate position 3. -
Page 23: Maintenance
Maintenance Recommended Maintenance Schedule Maintenance Service Maintenance Procedure Interval After First 8 Hours Change oil Check oil level Check safety system Each Use Check brake Clean air intake screen Check battery electrolyte Clean foam air cleaner Every 25 Hours Check tire pressure Grease chassis Check belts for wear/cracks Every 50 Hours... -
Page 24: Servicing The Engine Oil
Servicing the Engine Oil Change the oil after the first 8 operating hours and every 100 operating hours thereafter. Oil Type: Detergent oil (API service SF, SG, SH or SJ) Crankcase Capacity: when the oil filter is not removed, 51 oz. (1.5 l) when the oil filter is removed, 58 oz. -
Page 25: Cleaning The Cooling System
7. Slowly pour approximately 80% of the specified oil 3. Clean debris and grass from the parts. into the filler cap (Fig. 20). Refer to Servicing the 4. Install the air intake screen, cylinder covers, and fan Engine Oil, page 24. housing. -
Page 26: Servicing The Spark Plug
Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä Ä m–4289 Ä Ä Ä Ä Ä Ä Figure 24 m–4293 1. -
Page 27: Greasing And Lubrication
3. Push the wire(s) onto the spark plug(s) (Fig. 26). Greasing and Lubrication Grease the machine after every 50 operating hours or yearly, whichever occurs first. Grease more frequently when operating conditions are extremely dusty or sandy. Grease Type: General-purpose grease. How to Grease M–4294 1. -
Page 28: Checking The Tire Pressure
Checking the Tire Pressure 3. To adjust the brake remove the cotter pin and loosen the brake adjusting nut slightly (Fig. 30). Maintain the air pressure in the front and rear tires as 4. Carefully insert a 0.015 inch (0.38 mm) feeler gauge specified. -
Page 29: Servicing The Fuel Filter
Servicing the Fuel Filter 2. Stop the engine, remove the key, and wait for all moving parts to stop before leaving the operating position. Replace the fuel filter after every 100 operating hours or yearly, whichever occurs first. 3. Close the fuel shut–off valve at the fuel tank (Fig. 31). Replacing the Fuel Filter Never install a dirty filter if it is removed from the fuel line. -
Page 30: Transaxle Fluid
Servicing the Fuses 5. The front measurement should be less than the rear, as specified. Service Interval/Specification The electrical system is protected by fuses. It requires no maintenance, however, if a fuse blows check component/circuit for malfunction or short. To replace fuses pull up on the fuse (Fig. -
Page 31: Servicing The Battery
Servicing the Battery 5. Push and rotate the bulb counterclockwise until it stops (approx. 1/4 turn) and remove bulb from the bulb holder (Fig. 36). Warning CALIFORNIA Proposition 65 Warning Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. - Page 32 2. Stop the engine, remove the key, and wait for all moving parts to stop before leaving the operating position. 3. Open the hood and locate the battery. 4. Remove the right side panel for clearance when removing battery (Fig. 38). Remove the screws and lift up the panel to clear the pin and slide panel tabs out from the steering tower.
- Page 33 Important Always keep the battery fully charged Danger (1.265 specific gravity). This is especially important to prevent battery damage when the temperature is below 32 F (0 C). Battery electrolyte contains sulfuric acid which is a deadly poison and causes severe burns. 1.
-
Page 34: Wiring Schematic
Wiring Schematic (Model 72201) -
Page 35: Wiring Schematic
Wiring Schematic (Model 72202) -
Page 36: Cleaning And Storage
Cleaning and Storage D. Restart engine and run it until it stops. E. Choke or prime the engine. Start and run engine 1. Disengage the power take off (PTO), set the parking until it will not start. Operate primer, if equipped brake, and turn the ignition key to off. -
Page 37: Troubleshooting
Troubleshooting Problem Possible Causes Corrective Action Starter does not crank 1. Blade control (PTO) is 1. Move blade control (PTO) to ENGAGED. DISENGAGED. 2. Parking brake is not on. 2. Set parking brake. 3. Operator is not seated. 3. Sit on the seat. 4. - Page 38 Problem Possible Causes Corrective Action Abnormal vibration. 1. Engine mounting bolts are 1. Tighten engine mounting bolts. loose. 2. Loose engine pulley, idler 2. Tighten the appropriate pulley. pulley, or blade pulley. 3. Engine pulley is damaged. 3. Contact Authorized Service Dealer.
-
Page 40: The Toro Total Coverage Guarantee
If for any reason you are dissatisfied with your Distributor’s service or have difficulty obtaining guarantee information, contact the Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company.