Prepare For Rack-Mount Installation; Attach The Rack-Mount Brackets-Chassis Front-Mounted - Cisco ASR 1000 Series Quick Start Manual
Aggregation services routers
Hide thumbs
Also See for ASR 1000 Series:
- Software configuration manual (602 pages) ,
- Configuration manual (442 pages) ,
- Replacing (120 pages)
Table of Contents
Advertisement
Prepare for Rack-Mount Installation
Before you begin the rack-mounting tasks, decide whether or not you want to attach cable-management brackets to your chassis.
Note
If you install cable-management brackets, ensure that you use the rack-mount ear holes specified in the procedure
described in and install the brackets after the chassis is mounted on the equipment rack.
3
Rack-Mount the Router
This section provides information about rack-mounting the router.
Attach the Rack-Mount Brackets—Chassis Front-Mounted
To attach the rack-mount brackets on a Cisco ASR 1002-X Router for a front rack-mount configuration, follow these steps:
Step 1
Locate the threaded holes in the front sides of the chassis.
Step 2
Align the rack-mount bracket to the side of the router.
Step 3
Position the front rack-mount bracket's top hole with the chassis, first top hole behind the side vent holes, as shown in
Figure 1
Front Rack-Mount Brackets in the Cisco ASR 1002-X Router
2
3
1
1
Front rack-mount bracket ear and holes
Front rack-mount bracket
2
Step 4
Insert and tighten the black screws on one side.
Step 5
Repeat Step 1 through Step 4 on the other side of the chassis. Use black screws to secure the rack-mount brackets to
the chassis.
To install the cable-management brackets, see the procedure described in the
Step 6
section on page
4
6.
3
Front rack-mount bracket screws
— —
"Attach a Cable-Management Bracket"
Figure
1.
Advertisement
Table of Contents
