SC-R5000 Series/SC-R5000L Series User's Guide
C
Ink unit wire
When in use, be sure to use screws to fasten the ink unit wire to the front and back of the printer's legs. The ink
tube may break if you move the ink unit while it is connected to the printer without being fastened with the ink
unit wire.
D
Overturn-prevention plate
Make sure the ink unit is used with an overturn-prevention plate attached to both sides to prevent the ink unit
from overturning.
E
LED light
The LED lamp indicates, by lighting or flashing, the ink supply units inserted into their ink supply unit trays
and the ink unit, as shown below.
Lit blue
: Ink is being supplied to the printer. Do not pull out the ink supply unit tray.
Flashing blue
: It is time to shake the ink supply unit. Pull out the ink supply unit tray and shake it.
Lit or flashing orange: An error or warning has occurred. The type of error or warning is indicated by how the
Off
: No error. You can pull out the ink supply unit tray if necessary.
F
Ink supply unit tray
Insert the ink supply unit for the color indicated on the label. Place all of the ink supply unit trays in the ink unit.
G
Lock switch
To pull out an ink supply unit tray, unlock it by moving the lock switch to the right. After placing the ink
supply unit tray in the ink unit, lock it by moving the lock switch to the left.
H
Ink tube
This tube supplies ink from the ink supply unit to the printer.
I
Ink tube connector
This connector connects the ink tube and the printer. This is used with the ink tube and printer connected
normally, except for when transporting the printer.
J
Connector lock levers
Locks the ink tube connector. Do not use this after it is locked during setup.
Introduction
"Shaking" on page 87
U
lamp lights or flashes. You can check the details of the error or warning on the control
panel's screen.
15