Epson SC-R5000 Series User Manual page 113
Hide thumbs
Also See for SC-R5000 Series:
- Setup manual (41 pages) ,
- Repair manual (24 pages) ,
- Service manual (19 pages)
Table of Contents
Advertisement
SC-R5000 Series/SC-R5000L Series User's Guide
Item
Media
Media Type
Media Width
Pass Mode
Advanced Settings
Print Adjustments
Automatic Adjustment
Manual Adjustment
Media Feed Adjust-
ment
Print Head Alignment
Media Management
01 XXXXXXXXXX to 50 XXXXXXXXXX
Remaining Amount Management
Remaining Amount
Management
Remaining Amount
Remaining Alert
Control Panel Menu
Parameter
Explanation
01 XXXXXXXXXX to
Choose the media settings to use. The registered name appears in
50 XXXXXXXXXX
XXXXXXXXXX.
Displays the currently selected Media Type. This cannot be changed.
Set the Media Detection items.
Displays the currently selected Pass Mode. This can be changed.
You can change the Advanced Settings for the registered media
selected in Media.
See the following table for details on the setting content.
U
Perform Automatic Adjustment in the following cases.
❏
❏
Manual (Standard)
❏
Manual
If an error occurs when you perform Automatic Adjustment, or if you
(Measurement)
notice banding or graininess in the print results, perform Manual
Adjustment.
See the following for more information.
U
U
On
When On is selected, you can set Remaining Amount and Remaining
Alert. Setting each item to manage the remaining amount makes it
*
easier to know when it is time to replace the media.
Off
When this is set to On, once you have loaded the media and selected
the registered media settings number, you will be prompted to enter
the media length (Remaining Amount).
1.0 to 999.9 m
Set the total length of the loaded media. You can set in 0.1 m
*
increments. The amount of media remaining is estimated based on the
(50.0 m
)
length you set here and the length of the printout, and is displayed on
(3.3 to 3280.5 feet
the Home screen.
[164.0*])
*
Set a value at which point a warning message is displayed to inform you
1.0 to 15.0 m (5 m
)
that the remaining amount of media is too low. You can set in 1 m
(3.3 to 49.2 feet
increments. Depending on settings such as Media Back Feed after
[16.4*])
Curing, a media end error may occur when the remaining amount of
media is below approximately 1.6 m.
"Media Management items" on page 114
When registering media settings in the EMX file to the printer
When changing Advanced Settings after saving media settings
When the media type is the same but the width is different
"Optimizing Media Settings (Automatic Adjustment)" on page 61
"Media Management items" on page 114
113
- Quick Links:
- Table of Contents
- Illustrations
Hide quick links:
Advertisement
Chapters
Table of Contents
