hit counter script

Day 0 Cli Wizard For The Controller - Cisco Catalyst 9800-L Series Hardware Installation Manual

Wireless controller
Hide thumbs Also See for Catalyst 9800-L Series:
Table of Contents

Advertisement

Power Up and Initial Configuration
• [Optional] Configuring a virtual IP.
• [Optional] Configuring an RF network name.
• [Optional] Configuring high avalability.
Note
Presently, there is no direct method to get back to your previous configuration. Press Ctrl-C to restart the
configuration and return to the setup without saving the configuration.

Day 0 CLI Wizard for the Controller

Procedure
Step 1
You can get into the Day 0 setup wizard using the write erase command or directly on the Day 0 device.
Step 2
Device management interface setup configures the device management or service port. This interface enables
the basic configuration to access the device using the GUI. This is an optional configuration where you can
opt to configure only the wireless management interface and not the device management.
Configure device management interface?[yes]:
Step 3
Device management IP helps access the device using the GUI.
Configure static IP address? [yes]:
Step 4
Setting a static route to access the device using the GUI.
Interface belongs to VRF "Mgmt-intf". Please configure a static route on the VRF
Enter the destination prefix: 0.0.0.0
Enter the destination mask: 0.0.0.0
Enter the forwarding router IP: 10.104.170.1
Step 5
Enter the management username and password. This is a mandatory step.
Enter the management username: cisco
Enter the password: ********
Reenter the password: ********
Step 6
Configure the wireless management if you haven't configured a device management interface.
Basic management setup is now complete. At this point, it is possible to save the above and
continue wireless setup using the webUI (for this, choose 'no' below)
Would you like to continue with the wireless setup? [yes]: yes
Note
Enter the interface IP [TwoGigabitEthernet0/0/2]: 192.168.1.10
Enter the subnet mask [TwoGigabitEthernet0/0/2] [255.0.0.0]: 255.255.255.0
This prompt is not applicable for 17.4 release.
Cisco Catalyst 9800-L Wireless Controller Hardware Installation Guide
Day 0 CLI Wizard for the Controller
33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 9800-l-c rj45Catalyst 9800-l-f sfp

Table of Contents