Connecting The Antennas - Yamaha RX-V2500 Owner's Manual
Yamaha av receiver ampli-tuner audio-video owner's manual
Hide thumbs
Also See for RX-V2500:
- Product catalog (44 pages) ,
- Owner's manual (112 pages) ,
- Service manual (119 pages)
Table of Contents
Advertisement
Connecting the antennas
Both AM and FM indoor antennas are included with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
Indoor FM antenna
(included)
TUNER
FM ANT
75Ω
UNBAL.
GND
AM
ANT
COMPONENT VIDEO
Y
P
P
B
R
DVD
DTV
DTV
CBL/
SAT
MONITOR
OUT
Ground (GND terminal)
For maximum safety and minimum interference,
connect the antenna
ground. A good earth ground is a metal stake driven
into moist earth.
Connecting the AM loop antenna
1
Set up the AM loop antenna, then connect it
to the terminals on this unit.
2
Press and hold the tab to insert the AM loop
antenna lead wires into the AM ANT and GND
terminals.
AM loop antenna
(included)
GND
terminal to a good earth
3
Orient the AM loop antenna for the best
reception.
Notes
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
• A property installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality, an
outdoor antenna may improve the quality. Consult the nearest
authorized YAMAHA dealer or service center about outdoor
antennas.
75-ohm/300-ohm antenna adapter
(U.K. model only)
1
Open the cover of the
included 75-ohm/300-ohm
antenna adapter.
2
Cut the external sleeve
of the 75-ohm coaxial
cable and prepare it for
connection.
3
Cut the lead wire and
remove it.
4
Insert the cable
wire into the slot,
and clamp it with
pliers.
Insert the wire
into the slot
5
Snap the cover into place.
CONNECTIONS
11 (7/16)
Unit:
8 (5/16)
mm (in)
6 (1/14)
Lead wire
Clamp
Clamp
23
Hide quick links:
Advertisement
Table of Contents
