Toro TimeCutter MX 4200 Setup Instructions
Hide thumbs
Also See for TimeCutter MX 4200:
- Operator's manual (60 pages) ,
- Operator's manual (52 pages) ,
- Operator's manual (52 pages)
Advertisement
Quick Links
TimeCutter
For All TimeCutter
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Note: Determine the left and right sides of the machine from the normal operating position.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Riding Mowers
Description
No parts required
Rear hitch
Bolt (5/16 x 1 inch)
Locknut (5/16 inch)
No parts required
No parts required
No parts required
Ignition key
Hose coupling (not included with CE
models)
Operator's Manual
Engine Operator's Manual
Operator training material
Register at www.Toro.com.
®
Riding Mowers
Qty.
–
1
2
2
–
–
–
1
1
1
1
1
Form No. 3388-201 Rev A
Setup Instructions
Use
Connect the battery.
Install the rear hitch.
Set up the motion-control levers.
Connect the seat-hold bar.
Check the mower adjustment.
Complete the setup.
Original Instructions (EN)
All Rights Reserved *3388-201* A
Printed in the USA.
Advertisement
Related Manuals for Toro TimeCutter MX 4200
Summary of Contents for Toro TimeCutter MX 4200
- Page 1 Operator's Manual Engine Operator's Manual Operator training material Note: Determine the left and right sides of the machine from the normal operating position. © 2014—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3388-201* A 8111 Lyndale Avenue South Printed in the USA.
- Page 2 Connecting the Battery Installing the Rear Hitch No Parts Required Parts needed for this procedure: Rear hitch Procedure Bolt (5/16 x 1 inch) Locknut (5/16 inch) WARNING CALIFORNIA Procedure Proposition 65 Warning Battery posts, terminals, and related Install the bracket to the frame as shown in Figure 2 and accessories contain lead and lead compounds, Figure 3.
- Page 3 Setting Up the Motion-control Levers No Parts Required Procedure 1. Locate the motion-control levers attached, but folded down on the machine. 2. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch). 3.
- Page 4 Checking the Mower Completing the Setup Adjustment Parts needed for this procedure: No Parts Required Ignition key Hose coupling (not included with CE models) Procedure Operator's Manual Engine Operator's Manual Adjust the side-to-side level and the front-to-rear blade slope. Use the relevant procedures in the Operator's Manual to verify Operator training material that the deck is level, and make any adjustments as necessary.