Yamaha CD-N500 Firmware Update Procedure
Hide thumbs
Also See for CD-N500:
- Owner's manual (283 pages) ,
- Additional information (9 pages) ,
- Owner's manual (108 pages)
Table of Contents
Advertisement
Quick Links
IMPORTANT NOTICE
Follow the instructions carefully and do not attempt any other procedures not specified in the
instructions provided by Yamaha.
Improperly updated products may cause improper operation, and any parts or service required to
restore proper operation will not be covered under the Yamaha Limited Warranty.
Choose from the following 2 methods to update to the latest firmware.
Click here for
In case of error, see the
[ 1. Firmware Update Through the Internet ]
Requirements:
Your network player is connected to the Internet if you can receive
Internet radio stations. (See ownerʼs manual for details)
STEP 1
Power on and enter SETUP mode
Press SETUP button on the remote control.
STEP 2
Start Update
Using the UP/DOWN buttons, select menu "7 Firmware Update"
and press ENTER button. After that, select "Network" using
LEFT/RIGHT buttons and press Enter button.
When "Press ENTER to start" is displayed, press Enter button again
for starting update.
Firmware Update Procedure for CD-N500
Firmware Update Through the Internet
(Connection to the Internet is required)
Click here for
(A USB thumb drive is required)
section
UP
LEFT
SETUP
ENTER
RIGHT
DOWN
Advertisement
Table of Contents
Related Manuals for Yamaha CD-N500
Summary of Contents for Yamaha CD-N500
- Page 1 Yamaha. Improperly updated products may cause improper operation, and any parts or service required to restore proper operation will not be covered under the Yamaha Limited Warranty. Choose from the following 2 methods to update to the latest firmware.
- Page 2 Firmware Update Procedure for CD-N500 note: DO NOT interrupt the power or press any buttons during the update. In case the power is accidentally cut off, the network player will restore original firmware. Perform the update procedure from STEP 1 again.
- Page 3 Firmware Update Procedure for CD-N500 note: DO NOT interrupt the power or press any buttons during the update. In case the power is accidentally cut off, the network player will restore original firmware. Perform the update procedure from STEP 1 again.
- Page 4 Firmware Update Procedure for CD-N500 STEP 4 Confirm updated firmware version Power on and press the SETUP button on the remote control and select ”6 Firmware Version” using the UP/DOWN buttons. Confirm that the firmware version has been updated. Congratulations!