Table of Contents
Advertisement
Installing Catalyst Switch Front Expansion Modules
This section covers the installation of the following expansion modules:
•
WS-X3001, 100BaseTX
•
WS-X3002, 4-port 10BaseT
•
WS-X3003, 3-port 10BaseF
•
WS-X3005, 100BaseF
•
WS-X3006, ATM
•
WS-X3007 and WS-X3008, 100VG AnyLAN
•
WS-X3009 and WS-X3010, Dual-port Fast Ethernet with ISL
Caution
installing or removing an expansion module. If the power is on, damage to the equipment may result.
The 100BaseTX Expansion Module
The single-port 100BaseTX expansion module (WS-X3001) is used to connect to computers, hubs,
servers, and other high-speed network devices. The following sections explain the installation, cable
connection, and network connection for the 100BaseTX expansion module. For a functional
description of the 100BaseTX and the Catalyst switch, see the chapter that discusses the theory of
operation in the Catalyst Stack Installation and Configuration Guide for your model of Catalyst
switch.
The 100BaseTX expansion module is shown in Figure 3.
Figure 3
Expansion modules are not hot-swappable. Always be sure that the power is off before
100BaseTX Module
XM IT
RC V
DI AG
LN K/F DX
1
Catalyst Matrix and Expansion Module Installation and Configuration Guide
Installing Catalyst Switch Front Expansion Modules
DU PL EX
FU LL
HA LF
1
W S -X 30 01
1
5
Advertisement
Table of Contents
