Table of Contents
Advertisement
Maintenance Menu Settings
The Maintenance menu lets you run nozzle checks, cleaning cycles, and other maintenance operations.
You can access the menu by pressing the OK or Menu button while the
Caution: Follow the instructions in the topic links below the table to use these menu settings correctly.
Setting
Nozzle Check
Head Cleaning
All Nozzles
Selected Nozzles
Cutter Maintenance
Head Maintenance
Head Cap Cleaning
Waste Ink Counter
Parent topic:
Related tasks
Replacing the Waste Ink Bottle
Aligning the Print Head
Replacing the Cutter
Options
—
Execute (Light)
Execute (Medium)
Execute (Heavy)
Adjust Cut Position
Replace Cutter
Yes
No
—
—
Using the Control Panel Menus
Description
Prints a nozzle check pattern that you
can visually inspect and then run head
cleaning if necessary.
Lets you clean all or selected nozzles,
based on the nozzle check pattern.
Select the lightest cleaning level first. If
nozzles are still clogged, select a
heavier cleaning.
Adjusts the cutter position in
increments of 0.039 inch (1 mm), from
–0.12 to 0.12 inch (–3 to 3 mm).
Replace Cutter: positions the cutter for
replacement.
Positions the print head for cleaning
using the head maintenance kit.
Positions the print head to allow access
to the caps for cleaning.
Lets you reset the waste ink counter if
you replace the waste ink bottle before
being prompted by a message on the
control panel.
54
tab is selected.
Hide quick links:
Advertisement
Table of Contents
