Cisco LightStream 1010 Configuration Note page 15

Atm switch processor module

Hide thumbs Also See for LightStream 1010:

Table of Contents

Figure 12

Slot 0

Slot 1

Slot 2

Slot 3

Slot 4

ASP Installation

ASP and CAM installation instructions are essentially the same, except the ASP does not support

hot-swapping.

The ASP is a required system component. Removing an ASP while the system is operating causes

the system to shut down and may damage the processor. Power off the system before removing the

ASP. For more information, see the section "Installing and Replacing the ASP."

Caution

Take the following steps to install an ASP or CAM:

Step 1

Step 2

Step 3

Slot Numbers

Handle ASP by the carrier edges only to prevent ESD damage.

Use a 1/4-inch ﬂat-blade screwdriver to loosen the ASPs, which are secured with two

captive installation screws. Then remove the ASP card from the slot.

Hold the ASP faceplate with one hand, place your other hand under the carrier and guide it

into the slot. Avoid touching the card. (See Figure 13.)

Place the back of the ASP in the slot and align the notch on the sides of the module carrier

with the groove in the slot.

LightStream 1010 ATM Switch Processor Module Configuration Note

Installing and Replacing the ASP

Table of Contents