Cisco PowerVu D9850 Quick Setup Instructions

For tv japan

Download this manual

Before you start, review the following information and enter your Receiver User Address:

Program to receive:

Program Provider:

Satellite & Transponder:

Polarization:

Downlink Frequency

Symbol rate:

Network ID:

FEC Rate:

Receiver User Address (UA): (found

on the rear panel)

Step-by-Step Instructions

1. Connect the L-Band signal to the RF IN connector.

Note that LNB power is only available via the RF input #1 for multiple RF models. The

factory default setting for RF 1 LNB power is OFF. (If you need the receiver to power

your LNB, details are provided in the User Manual shipped with the receiver.

2. Connect video and audio outputs to monitors.

3. Connect the AC power source. Wait for the receiver to fully boot up. Once ready, the

default status menu will appear [CH:XXX Name:XXXX] For an initial installation, the

channel number will be 0 and the channel name will be "Not Available".

4. Press Menu to move from the initial display into the Main Menu system.

5. Press the right arrow key so the cursor is to the left of the Preset/Input menu item.

Press the Select button to display the

QUICK SETUP INSTRUCTIONS

TV JAPAN

PowerVu D9850 Program Receiver

TV JAPAN

NHK Cosmomedia America, Inc.

Galaxy 13 4C

Vertical

L-band 1350 (03.800 GHz)

27.69 Msym/s

8002

3/4

Preset/Input

menu.

Page 1 QUICK SETUP INSTRUCTIONS TV JAPAN PowerVu D9850 Program Receiver Before you start, review the following information and enter your Receiver User Address: Program to receive: TV JAPAN NHK Cosmomedia America, Inc. Program Provider: Galaxy 13 4C Satellite & Transponder: Polarization:...
Page 2 6. Edit the Active Preset (default decoder settings) by using the down arrow and select to enter values for the Downink Frequency, Symbol Rate, Network ID, Polarization and Input as listed above. (Use the down arrow key to move through the available menus until the desired option is displayed).
Page 3 16. Press the right arrow key so the cursor is to the left of the TX out menu item. Press the TX out Select button to display the menu. 17. Select Service Channel Descrambled w/DPR option. Acquiring Network Information 18. Press Menu, the message should display.
Page 4 WSS Status Auto ¡ Caption Mode 0. Auto Aud# AC3 Compression Left Right ¡ aud1 Aud# Stereo/Mono ¡ aud1 STEREO ¡ Audio Decoder Aud1 Aud2 PMT Audio Source AUD1 AUD2 PowerVu D9850 Program Receiver Installation and Operation Guide 4006105 Rev B...
Page 5 Aud1 and AUD2 for audio channel Aud2. Possible options for the two stereo audio channels are AUD1 to AUD4. Note: These settings may be changed/overridden by the uplink. 4006105 Rev B PowerVu D9850 Program Receiver Installation and Operation Guide...