Advertisement
Figure 2 shows a close-up of the DSL interface module faceplate.
Figure 2
3
5
50-pin Champ connector for DSL slots 1
1
through 3
2
Cable tie-downs
Screws to secure the DSL interface module to
3
the chassis
The Cisco 6015 chassis follows the FCC part 68 industry standard convention for Tip and Ring
connections on the twisted pairs of the 50-pin Champ connector. The Champ connectors are pinned out
to accommodate quad-port or octal-port xTU-C line cards. If you are not currently using octal-port
xTU-C line cards but plan to in the future, Cisco recommends that you use Champ cables that can
accommodate higher density line cards. Refer to the Cisco 6015 Hardware Installation Guide for port
mapping tables.
Table 1
Table 1
Specification
Dimensions
Weight
Data connectors
Power consumption
Minimum software and
network management
requirement
1. CDM = Cisco DSL Manager
OL-2186-01
DSL Interface Module Faceplate
1
DSL SLOTS 1–3
DSL SLOTS 4–6
4
lists the specifications for the DSL interface module.
DSL Interface Module Specifications
Description
Height: 1.375 in. (3.493 cm)
Depth: 9.375 in. (23.813 cm)
Width: 3.375 in. (8.573 cm)
0.71 lb (0.32 kg)
Two 50-pin Champ connectors
Not applicable.
Cisco IOS—Release 12.1(4)DA
CDM
2
2
50-pin Champ connector for DSL slots 4
4
through 6
5
Extraction handle
1
—Release 3.2 (optional)
Introduction
3
Introduction
3
Advertisement
