Table of Contents
Advertisement
Available languages
Available languages
y
If the settings you have made are inappropriate, you can always reset all options and your personal settings to the initial factory settings.
For details, see "Resetting the system" on page 30.
Step 1: Inserting batteries into
the remote control
1
Press the
part and slide the battery
compartment cover off.
2
Insert the two supplied batteries (AAA, R03,
UM-4), following the indications (+/–) on the
inside of the compartment.
3
Slide the cover back until it snaps into place.
Notes
• Insert batteries correctly according to the polarity markings
(+/–). The batteries inserted in the opposite direction may leak.
• Replace the exhausted batteries immediately with new ones to
prevent a leakage.
• Remove the batteries from the compartment if the remote
control is not used for more than a month.
• If the batteries have leaked, dispose of them immediately.
Avoid touching the leaked material or letting it come into
contact with clothing, etc. Clean the battery compartment
thoroughly before installing new batteries.
• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline and
manganese batteries) together. Read the packaging carefully as
these different types of batteries may have the same shape and
color.
• Dispose of the batteries correctly in accordance with your local
regulations.
GETTING STARTED
3
2
1
Using the remote control
Use the remote control within 6 m (20 ft approx.) of this
unit and point it toward the remote control sensor.
Notes
• Do not spill water or other liquids on the remote control.
• Do not drop the remote control.
• Do not leave or store the remote control in the following types
of conditions:
– places of high humidity, such as near a bath
– places of high temperature, such as near a heater or stove
– places of extremely low temperature
– dusty places
Step 2: Turning on the power
1
Make sure that the power cable is connected to
an AC outlet.
2
Turn on your TV and AV receiver.
3
Select the appropriate input source of the AV
receiver connected to this unit. Refer to the
manual supplied with your AV receiver for
details.
4
Press STANDBY/ON on the front panel or
POWER (
) on the remote control to turn on
l
this unit.
The front panel display lights up.
5
Set the TV to the correct Video IN channel (e.g.,
EXT1/2, AV1/2, AUDIO/VIDEO, etc. Refer to
the manual supplied with your TV for details).
The default screen appears on the TV.
GETTING STARTED
within 6m
(20 ft approx.)
15
En
Advertisement
Chapters
Table of Contents
