Table of Contents
Advertisement
Installing the Controller
Figure 3: Inner Rail Release Clip
1
2
Step 5
(Optional) Secure the controller in the rack more permanently by using the two screws that are provided with the slide
rails. Perform this step if you plan to move the rack with controllers installed.
With the controller fully pushed into the slide rails, open a hinged slam latch lever on the front of the controller and insert
the screw through the hole that is under the lever. The screw threads into the static part of the rail on the rack post and
prevents the controller from being pulled out. Repeat for the opposite slam latch.
Installing the Cable Management Arm (Optional)
Note
The CMA is reversible left to right. To reverse the CMA, see
on page 8
Step 1
With the controller pushed fully into the rack, slide the CMA tab of the CMA arm that is farthest from the controller onto
the end of the stationary slide rail that is attached to the rack post (see
to the Rear of the Slide Rails, on page
Step 2
Slide the CMA tab that is closest to the controller over the end of the inner rail that is attached to the controller (see
4: Attaching the Cable Management Arm to the Rear of the Slide Rails, on page
rail until it clicks and locks.
Step 3
Pull out the width-adjustment slider that is at the opposite end of the CMA assembly until it matches the width of your
rack (see
Figure 4: Attaching the Cable Management Arm to the Rear of the Slide Rails, on page
Step 4
Slide the CMA tab that is at the end of the width-adjustment slider onto the end of the stationary slide rail that is attached
to the rack post (see
the tab over the end of the rail until it clicks and locks.
Step 5
Open the hinged flap at the top of each plastic cable guide and route your cables through the cable guides as desired.
Inner rail release clip
Inner rail attached to controller
before installation.
8). Slide the tab over the end of the rail until it clicks and locks.
Figure 4: Attaching the Cable Management Arm to the Rear of the Slide Rails, on page
Installing the Cable Management Arm (Optional)
3
Outer rail attached to rack post
Reversing the Cable Management Arm (Optional),
Figure 4: Attaching the Cable Management Arm
8). Slide the tab over the end of the
Installing the Controller
Figure
8).
8). Slide
7
Advertisement
Table of Contents
