Table of Contents
Advertisement
Problem
The appliance does
not operate.
The lamp does not op-
erate.
There is sparking in the
cavity.
There is sparking in the
cavity.
The turntable set
makes a scratching or
grinding noise.
The appliance stops
operating without a
clear reason.
SERVICE DATA
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
INSTALLATION
WARNING! Refer to Safety chapters.
GENERAL INFORMATION
CAUTION! Do not block the air vents.
If you do that, the appliance can
overheat.
CAUTION! Do not connect the
appliance to adapters or extension
leads. This can cause overloading and
risk of fire.
Possible cause
The door is not closed properly.
The lamp is defective.
There is a metal dish or a dish with
a metal trim inside.
There is a metal skewer or some
aluminium foil inside that touches
the interior walls.
There is an object or dirt below the
glass cooking tray.
There is a malfunction.
We recommend that you write the data here:
Make sure that nothing blocks the
door.
The lamp has to be replaced.
Remove the dish from the appli-
ance.
Make sure that the skewer or foil
does not touch the interior walls.
Clean the area below the glass
cooking tray.
If this situation repeats itself, call
the Authorised Service Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the appliance. Do
not remove the rating plate from the appliance.
........................................
........................................
........................................
CAUTION! The minimum installation
height is 85 cm.
•
The microwave is for built-in use only. It must be
placed on a stable and flat surface.
•
The cabinet can not have a back wall in the
place where the microwave is located.
•
Put the microwave far away from steam, hot air
and water splashes.
•
If the microwave is too close to a radio or TV set
it may cause interference in the received signal.
•
If you transport the microwave in the cold
weather, do not activate it immediately after the
installation. Let is stand in the room temperature
and absorb the heat.
Remedy
15
Advertisement
Table of Contents
