Table of Contents
Advertisement
Installing the Cisco ASR 920-10SZ-PD and Cisco ASR-920-8S4Z-PD Routers
Connecting the Chassis Ground and Power
Before you connect the power or turn on power to the router, you must provide an adequate chassis ground
(earth) connection to your router.
Grounding the Router
The router provides a grounding point on either side of the unit for a two-hole lug.
Caution
Before making connections to the router, ensure that you disconnect the power at the circuit breaker. Otherwise
it may result in severe injury to yourself, or damage to the router.
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence
of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician
if you are uncertain that suitable grounding is available. Statement 1024
Warning
Use copper conductors only. Statement 1025
Warning
When installing the unit, the ground connection must always be made first and disconnected last. Statement
42
The following figure shows one of the grounding points of the router, for ease of installation. The other
grounding point is on the front panel, which can also be used for grounding the router.
Effective July 2018, the Cisco ASR-920-10SZ-PD rear panel is remodeled. All installation procedures,
however, remain the same. The following figure shows the remodeled rear Cisco ASR 920-10SZ-PD Router.
Figure 16: Grounding Point on the Router
1
Grounding point
Cisco ASR 920-10SZ-PD and Cisco ASR-920-8S4Z-PD Aggregation Services Router Hardware Installation Guide
Connecting the Chassis Ground and Power
37
Hide quick links:
Advertisement
Table of Contents
