Advertisement
Quick Links
Air Ride Seat Suspension Kit
Reelmaster
Model No. 03667
Installation
1. Position the machine on a level surface, lower the
cutting units, stop the engine, engage the parking brake
and remove the key from the ignition.
2. Disconnect the negative battery cable from the battery.
3. Disconnect the seat switch wire from the harness at
the rear of the control arm.
4. Remove the (2) adjusting bolts securing the control
arm to seat mount (Figure 1). Carefully set the control
arm aside.
Note: Make sure not to damage the wire harness or
the throttle cable.
1. Control arm adjusting bolts
(2)
5. Remove the (4) nuts securing the seat adjusters and the
manual tube clamps to the seat suspension (Figure 2).
Also, remove the (4) washers between the seat adjusters
and seat suspension. Carefully set the seat assembly
aside.
6. Remove the (4) bolts, spacers and nuts securing the
lower seat brackets to the seat base (Figure 2). Remove
the seat suspension and seat brackets from the seat
base. Use caution not to misplace the spacers during
removal.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
5010 Series Traction Unit
1
2
g026049
Figure 1
2. Control arm access panel
Register at www.Toro.com.
7. Remove the (4) bolts securing the seat suspension to
the lower seat brackets (Figure 2). Retain the bolts and
brackets for reuse.
Note: When assembling the seat components, use the
front mounting holes in the seat and the rear mounting
holes in the suspension.
8. Secure the air ride seat suspension to the lower seat
brackets with the (4) bolts previously removed (Figure
2).
Figure 2
1. Seat assembly
2. Washer (4)
3. Seat suspension
4. Manual tube R–clamp (2)
Original Instructions (EN)
All Rights Reserved *3385-268* A
Printed in the USA.
Form No. 3385-268 Rev A
Installation Instructions
5. Seat base
6. Spacer
7. Lower seat brackets
Advertisement
Related Manuals for Toro 03667
Summary of Contents for Toro 03667
- Page 1 Form No. 3385-268 Rev A Air Ride Seat Suspension Kit Reelmaster ® 5010 Series Traction Unit Model No. 03667 Installation Instructions Installation 1. Position the machine on a level surface, lower the 7. Remove the (4) bolts securing the seat suspension to cutting units, stop the engine, engage the parking brake the lower seat brackets (Figure 2).
- Page 2 9. Mount the lower seat brackets to the seat base with the 20. Install the access panel to the control arm (Figure 1). (4) bolts, spacers and nuts previously removed (Figure 21. Plug the traction unit power harness, from back of control arm into the seat harness connector.