Verifying And Saving Your Configuration - Cisco VG202 Quick Start Manual
Voice gateways
Hide thumbs
Also See for VG202:
- Hardware installation manual (50 pages) ,
- Software configuration manual (50 pages) ,
- Manual (10 pages)
Table of Contents
Advertisement
ip address 172.1.2.3 255.255.0.0
!
Step 11 Respond to the following prompts. Enter 2 to save the initial configuration.
[0] Go to the IOS command prompt without saving this config.
[1] Return if possible to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
VG>
Verifying and Saving Your Configuration
To verify the configuration and save it in NVRAM so that the configuration remains in effect after you restart the voice gateway,
enter the following commands:
Command
Step 1
VG# show running-config
Step 2
VG# show startup-config
Step 3
VG# show voice port summary
Step 4
VG# copy running-config startup-config
Americas Headquarters
Cisco Systems, Inc.
San Jose, CA
Cisco has more than 200 offices worldwide. Addresses, phone numbers, and fax numbers are listed on the Cisco Website at www.cisco.com/go/offices.
Printed in the USA on recycled paper containing 10% postconsumer waste.
OL-xxxxx-xx
Description
Displays the current operating configuration, including any
changes you have made.
Displays the configuration currently stored in NVRAM.
Displays the voice port parameter settings.
Writes the current running configuration to NVRAM, where it
overwrites the startup configuration and becomes the new startup
configuration.
Note
Asia Pacific Headquarters
Cisco Systems (USA) Pte. Ltd.
Singapore
If you reboot the voice gateway or turn off the power
before you complete this step, you lose the configuration.
Europe Headquarters
Cisco Systems International BV Amsterdam,
The Netherlands
Hide quick links:
Advertisement
Table of Contents
