Table of Contents
Advertisement
Problem
No display LED on
the front panel;
No power supply
No pictures on the screen
No sound
Remote Control does not
operate directly
Poor picture quality
On-Screen Error Message
"Searching for signal"
On-Screen Error Message
"Channel data
does not exist."
On-Screen Error Messages:
"Please check the
Smartcard";
"Please insert the
Smartcard".
DISPOSAL
The device, packaging material (e.g. Styrofoam) and the batteries
must never be disposed of with household refuse.
Please obtain appropriate information about the regulations in your community,
and dispose of all refuse in accordance with regulations at the separate
locations provided.
TROUBLESHOOTING
Possible cause
Power cord
not plugged in correctly
Receiver in Standby mode;
Scart not connected tightly
to video output of television;
incorrect channel or video
output selected on television
Audio cord connected
incorrectly;
Loudness level = 0;
Muting active
incorrect operation;
Batteries dead or inserted
incorrectly
Signal strength to low
Antenna cable not connected
or not tight;
LNB defective;
incorrect position of the
satellite antenna;
Satellite not yet set
Smartcard:
- not plugged in correctly;
- not plugged in.
GB-30
Solution of the problem
Power cord plug in correctly
Set receiver to "On";
Check connection and correct;
Check channel and video output and
correct (TV instruction manual)
Check connection and correct;
Increase loudness on television set;
Press the MUTE key
Point remote control
towards the Receiver.
Replace batteries or insert correctly
Check the signal strength in
the "Auto Scan" menu, correct alignment
of your antenna
Check connection and correct;
Change LNB;
Check position and correct,
Check the signal strength in
the "Auto Scan" menu
Scan of in "Automatic scanning"
or "Manual scanning" menu
(depend on model)
Check the Smartcard.
"Insert the Smartcard."
D
I
G
I
T
A
L
S
A
T
E
L
Advertisement
Table of Contents
