Table of Contents
Advertisement
Access the System Admin Console
Compare the displayed version with the boot image version. The versions need to be the same.
Access the System Admin Console
All system administration and hardware management setups are performed from the System Admin console.
Procedure
Step 1
Login to the XR console as the root user.
Step 2
admin
Example:
RP/0/RP0/CPU0:ios# admin
Wed Jul 29 18:05:14.280 UTC
root connected from 127.0.0.1 using console on xr-vm_node0_RP1_CPU0
sysadmin-vm:0_RP0#
After you enter the System Admin console, the prompt changes to:
sysadmin-vm:0_RP0#
Step 3
(Optional) exit
Example:
sysadmin-vm:0_RP0# exit
Wed Jul
RP/0/RP0/CPU0:ios#
Return to the XR CLI from the System Admin CLI.
Configure Management Interface
To use the management interface for system management and remote communication, you must configure
an IP address and subnet mask for the management ethernet interface. To communicate with devices on other
networks (such as remote management stations or TFTP servers), you need to configure a default (static) route
for the NCS 1002.
The range of supported MTU of management plane is 64 to 1514 bytes.
Before you begin
• Consult your network administrator or system planner to procure IP addresses and a subnet mask for the
System Setup and Software Installation Guide for Cisco NCS 1002
12
29 18:05:15.994 UTC
management port.
Bring-up Cisco NCS 1002
- Quick Links:
- Boot Ncs 1002 Using Usb Drive
Hide quick links:
Advertisement
Table of Contents
