Table of Contents
Advertisement
Removing and Installing the WS-F6K-48-AF Inline-Power Daughter Card
Carefully remove the inline-power daughter card from the Ethernet module and set it on an antistatic mat
Step 4
or antistatic foam.
Step 5
If you are installing a replacement WS-F6K-48-AF inline-power daughter card, go to the
WS-F6K-48-AF Inline-Power Daughter Card" section on page
module back into the chassis, go to the
Installing the WS-F6K-48-AF Inline-Power Daughter Card
To install the WS-F6K-48-AF inline-power daughter card on the Ethernet module, perform these steps:
Position the inline-power daughter card over the module and carefully align the three threaded studs on
Step 1
the module with the corresponding holes in the inline-power daughter card. (See
aligns the inline-power daughter card connectors with the module connectors.
Figure 31
Catalyst 6500 Series Power over Ethernet Daughter Cards Field-Upgrade Installation Note
36
"Installing the Ethernet Switching Module" section on page
Positioning the Inline-Power Daughter Card Over the Module (WS-F6K-48-AF)
Daughter card
"Installing the
36. If you are installing the Ethernet
Figure
31.) This step
39.
78-10826-08
Advertisement
Table of Contents
