Installing The Chassis; Connecting To Network Interfaces - Cisco ASA 5505 Getting Started Manual
Hide thumbs
Also See for ASA 5505:
- Configuration manual (1822 pages) ,
- Getting started manual (168 pages) ,
- Administrator's manual (118 pages)
Table of Contents
Advertisement
Installing the Chassis
Installing the Chassis
Step 1
Step 2
Step 3
Connecting to Network Interfaces
Step 1
Step 2
Cisco ASA 5505 Getting Started Guide
3-4
To install the ASA 5505, perform the following steps:
Place the chassis on a flat, stable surface. The chassis is not rack mountable.
Connect Port 0 to the public network (that is, the Internet):
Use the yellow Ethernet cable to connect the device to a switch or hub.
a.
Use the orange Ethernet cable to connect the device to a cable/DSL/ISDN
b.
modem.
By default, switch port 0/0 is the outside port.
Note
Connect your network devices with an Ethernet cable to one of the seven switched
ports (numbered 1 through 7).
If you are connecting any Power over Ethernet (PoE) devices, connect them to one
of the switch ports that support PoE (ports numbered 6 and 7).
To connect to a network interface, perform the following steps:
Locate an RJ-45 to RJ-45 Ethernet cable.
Connect one end of the Ethernet cable to an Ethernet port (ports 0 through 7) as
shown in
Figure
3-2. (Typically Ethernet port 0 is used to connect to an Internet
router.)
Chapter 3
Installing the ASA 5505
78-17612-01
- Quick Links:
- Ports and Leds
Hide quick links:
Advertisement
Table of Contents
