Advertisement
LIFT-UP
COOKTOP
The cooktop can be raised
or removed
so the area
underneath (burner box bottom) can be cleaned.
To raise ¢ooktop:
1. Remove the burner grates, bowls and knobs.
2. Grasp the cooktop at the front and lift up.
3. Raise the support rod Into place to hold the cooktop
while cleaning. Securethe rodlnto the spacer bracket
on the cooktop.
Porcelain enamel can chip If dropped. Handle porcelain
enameled cooktops carefully.
To lower
the cooktop:
1. Carefully
replace
the support
rod and lower the
cooktop.
Press into place. Make sure the strikes fit
in the catches to fasten the cooktop.
2. Replace the burner grates, bowls and knobs.
REMOVABLE
COOKTOP
BURNERS
The cooktop burners on your range may be removed for
cleaning. Be sure all cooktop
knobs are turned
to
OFF and burners
are cool,
then rentove
or raise
the cooktop.
If shipping screws were not removed from the burner
when the range was Installed, do so now (see your
Installation section for Instructions).
To remove
burners:
1. Grasp the burner head and tilt It to the right to release
the two tabs from the burner support (A In Fig. A).
2. Lift the end of the burner assembly, then pull away
from the front of the range to free the air shutter from
the gas valve orifice (Fig. B). Check all lighter and
burner ports. If they are clogged, use a wire or needle
to clear them.
See the Cleaning Chart.
Be careful
not to disturb
the air shutter
setting
while cleaning.
If you need to readjust the air shutter,
see the Installation Section.
To replace
burners:
1. Sliptheair
shutterover
the gas valve orifice (Fig. A).
2. Lower the burner assembly and hook the tab in the
slots In the burner support (Fig. A).
3. Be sure both tabs are in their slots, that the burner
sits level and straight and that the flash tube forms a
straight line from the igniter to the burner (Fig. B).
GAS VALVE
ORIFICE
AIR SHUTTER
MGHTER PORTS
IGNITE_
_
_
FLASH TUBE
BURNER PORTS
11
NGMN_5-1
Advertisement
