Table of Contents
Advertisement
Configuring Control Plane Policing
If you are familiar with the Cisco IOS CLI, be aware that the Cisco NX-OS commands for this feature
Note
might differ from the Cisco IOS commands that you would use.
Default Settings for CoPP
This table lists the default settings for CoPP parameters.
Table 15: Default CoPP Parameters Settings
Parameters
Default policy
Default policy
Scale factor value
Configuring CoPP
This section describes how to configure CoPP.
Configuring a Control Plane Class Map
You must configure control plane class maps for control plane policies.
You can classify traffic by matching packets based on existing ACLs. The permit and deny ACL keywords
are ignored in the matching.
You can configure policies for IP version 4 (IPv4) and IP version 6 (IPv6) packets.
Before You Begin
Ensure that you have configured the IP ACLs if you want to use ACE hit counters in the class maps.
Procedure
Step 1
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
Cisco Nexus 3600 NX-OS Security Configuration Guide, Release 7.x
Default Settings for CoPP
Default
Strict
9 policy entries
The maximum number of supported policies
Note
with associated class maps is 128.
1.00
Purpose
Enters global configuration mode.
127
Hide quick links:
Advertisement
Table of Contents
