Removal - NEC EXP320R Maintenance Manual
Nec express server express5800 series vmware
Hide thumbs
Also See for EXP320R:
- Maintenance manual (268 pages) ,
- Installation manual (88 pages) ,
- User manual (86 pages)
Table of Contents
Advertisement
Chapter 2 Configuring and Upgrading the System
5.4.1 Removal
Follow the procedure below to remove the CPU/IO module.
1.
Stop the CPU/IO module you want to remove.
To stop the CPU/IO module, run the ftsmaint command on the console OS.
Refer to Chapter 1 (4. Maintenance of Express5800/ft series) for details.
If the CPU/IO module to be removed is CPU/IO module 0, stop the CPU module 0 first as follows.
# cd /opt/ft/bin
# ./ftsmaint bringdown 0
With the following command, check that the Status of the CPU module is OFFLINE.
# ./ftsmaint ls 0
Similarly, stop the I/O module 0.
# ./ftsmaint bringdown 10
Check that the Status of the I/O module 0 is OFFLINE.
# ./ftsmaint ls 10
2.
Remove the front bezel
3.
Disconnect the power cord of a module to be removed.
The stopper will go down when you disconnect the cable.
Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Maintenance Guide (VMware)
120
Tips
When removing CPU/IO module 1, select [Bring Down] for CPU module 1 and I/O
module 1
Note
Check whether the stopper goes down after disconnecting the power cord. If you
disconnect the cable and the stopper does not go down, you cannot pull out the CPU/IO
module in the next step.
5. Installing and Replacing Optional Devices
Stopper
Advertisement
Table of Contents
