Table of Contents
Advertisement
Please change your password from the default
settings. Please change the password for better
protection of your network. Do you want to change
the password (Y/N) [Y]?
Select Y, and enter a new administrator password.
S
6
TEP
You are now ready to configure the switch. Refer to the
MS200X Series 24-Port 10/100 Ethernet Access Switches
Command Line Reference
Make sure that any configuration changes made are saved
N
OTE
before exiting.
Troubleshoot Your Connection
If you cannot access your switch from the web-based interface, the switch
may not be reachable from your computer. You can test network
connections by using ping on a computer running Windows:
Open a command window by using Start > Run and enter cmd.
S
1
TEP
At the Command window prompt enter ping and the switch IP
S
2
TEP
address. For example ping 192.168.1.254 (the default static IP
address of the switch).
If you can reach the switch, you should get a reply similar to the
following:
Pinging 192.168.1.254 with 32 bytes of data:
Reply from 192.168.1.254:bytes=32 time<1ms TTL=128
If you can reach the switch, you should get a reply similar to the
following:
Pinging 192.168.1.254 with 32 bytes of data:
Request timed out.
Returning the MS200X Switch to the
6
Factory Default Settings
To use the RESET button to reboot or reset the switch, do the following:
• To reboot the switch, press the RESET button for less than ten seconds.
• To restore the switch to its factory default settings, press-and-hold the
RESET button for more than ten seconds.
22
Cisco MS200X Series 10/100 24-Port Ethernet Access Switches
for further information.
Cisco
Hide quick links:
Advertisement
Table of Contents
