Mpls Ldp-Igp Synchronization Compatibility With Ldp Graceful Restart; Mpls Ldp-Igp Synchronization Compatibility With Igp Nonstop Forwarding - Cisco NCS 5500 Series Configuration Manuals
Routing configuration ios xr release 6.3.x
Hide thumbs
Also See for NCS 5500 Series:
- Configuration manual (172 pages) ,
- Hardware installation manual (146 pages) ,
- Manual (25 pages)
Table of Contents
Advertisement
MPLS LDP-IGP Synchronization Compatibility with LDP Graceful Restart
LDP IGP auto-configuration can also be explicitly disabled on individual interfaces under LDP using the igp
auto-config disable command. This allows LDP to receive all IGP interfaces except the ones explicitly
disabled.
See the MPLS configuration guide for information on configuring LDP IGP auto-configuration.
MPLS LDP-IGP Synchronization Compatibility with LDP Graceful Restart
LDP graceful restart protects traffic when an LDP session is lost. If a graceful restart-enabled LDP session
fails, MPLS LDP IS-IS synchronization is still achieved on the interface while it is protected by graceful
restart. MPLS LDP IGP synchronization is eventually lost under the following circumstances:
• LDP fails to restart before the LDP graceful restart reconnect timer expires.
• The LDP session on the protected interface fails to recover before the LDP graceful restart recovery
MPLS LDP-IGP Synchronization Compatibility with IGP Nonstop Forwarding
IS-IS nonstop forwarding (NSF) protects traffic during IS-IS process restarts and route processor (RP) failovers.
LDP IS-IS synchronization is supported with IS-IS NSF only if LDP graceful restart is also enabled over the
interface. If IS-IS NSF is not enabled, the LDP synchronization state is not retained across restarts and failovers.
Routing Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.3.x
44
timer expires.
Implementing IS-IS
Hide quick links:
Advertisement
Table of Contents
