Table of Contents
Advertisement
2
• To enable the write-protection function (the "ON" setting), turn
the rotary encoder counterclockwise as seen from the front of the
camera.
• To disable the write-protection function (the "OFF" setting), turn
the rotary encoder clockwise.
If data cannot be written
If when you press the rotary encoder in step 6 of the foregoing procedure
(page 4-116) one of the following error messages appears, then the data
4
was not written.
Error message
CARD NOT
INSERTED!
WRITE
PROTECTED!
WRITE ERROR!
(flashing)
Reading saved data from a card
Follow the procedure below.
1,2,7
4,6
4-120
Chapter 4 Adjustments and Settings for Recording
Data write error messages
Reason
No setup card is
inserted.
WRITE PROTECT
is set to ON.
Circuit or card fault Check the circuitry, or replace the
Reading saved data from a card
Action
Close the menu and insert or
reinsert the card.
Set WRITE PROTECT to OFF.
card with a verified card.
3,5
Advertisement
Table of Contents
