Page 1
XR-4750RDS/C450RDS SERVICE MANUAL AEP Model UK Model Ver 1.1 2001.06 For RM-X2S (Remote Commander), Photo: XR-C450RDS please refer to RM-X2S/X3S Service Manual (9-960-039-S) previously issued. Model Name Using Similar Mechanism Tape Transport Mechanism Type MG-25B-136 SPECIFICATIONS FM/MW/LW CASSETTE CAR STEREO...
TABLE OF CONTENTS SERVICING NOTES GENERAL Flexible Circuit Board Repairing • Keep the temperature of the soldering iron around 270 ˚ C during Location of Controls ............3 Setting the Clock ............... 4 repairing. • Do not touch the soldering iron on the same conductor of the Using the Rotary Remote ..........
SECTION 2 DISASSEMBLY Note: Follow the disassembly procedure in the numerical order given. FRONT PANEL ASS’Y 1 Push the button (release). 2 Remove the front panel ass’y to the direction of the arrow A . COVER ASS’Y 3 cover ass’y –...
SECTION 3 ASSEMBLY OF MECHANISM DECK Note: Follow the assembly procedure in the numerical order given. HOUSING 7 Hold the hanger by bending the claw. 5 Fit projection on C part. 2 Install the hanger onto 1 Install the catch to the hanger. two claws of the housing.
Page 13
LEVER (LDG-A) / (LDG-B) shaft A shaft A shaft B shaft C shaft C 1 Fit the lever (LDG-A) on 4 type-E stop ring 2.0 shafts A – C and install it. 2 Pull the lever in the arrow direction. 3 Fit the lever (LDG-B) on shafts A and C and install it.
Page 14
GUIDE (C) 2 guide (C) 1 three claws – 14 – Downloaded from www.Manualslib.com manuals search engine...
SECTION 4 SECTION 5 MECHANICAL ADJUSTMENTS ELECTRICAL ADJUSTMENTS PRECAUTION TEST MODE This set have the test mode function. In the test mode, FM Auto 1. Clean the following parts with a denatured-alcohol-moistened Scan/Stop Level and AM (MW) Auto Scan/Stop Level adjustments swab: can be performed easier than it in ordinary procedure.
FM Stereo Separation Adjustment TUNER SECTION 0dB=1µV Setting: SOURCE button: FM Cautions during repair When the tuner unit is defective, replace it by a new one because FM RF signal level meter antenna jack (J1) generator its internal block is difficult to repair. 0.01 µ...
Page 17
FM Signal Meter Adjustment AM (MW) Auto Scan/Stop Level Adjustment Setting: Make this adjustment after “FM Auto Scan/Stop Level Adjustment”. SOURCE button: FM Setting: SOURCE button: MW FM RF signal generator antenna jack (J1) 30 Ω 15 pF 0.01 µ F 65 pF Carrier frequency : 98.00 MHz : 35 dB (56.2 µ...
Page 18
Adjustment Location: – SET UPPER VIEW – Tape Speed Adjustment RV1 AM (MW) Auto Scan/Stop Level Adjustment RV2 FM Auto Scan/Stop Level Adjustment RV3 FM Noise Focus Adjustment RV4 FM Stereo Separation Adjustment FM Signal Meter Adjustment – 18 – Downloaded from www.Manualslib.com manuals search engine...
Page 21
IC601 BA3918-V2 IC701 BA8270F-E2 (XR-C450RDS only) BUS ON BUS ON SWITCH REGULATOR RESET SWITCH BUS ON CLK IN BATTERY BATT BU IN SWITCH OVER VOLTAGE PROTECT VREF DATA IN DATA – DATA OUT 2 3 4 • Waveforms 1 IC1 1 XO 2 IC3 9 XO 42 mVp-p 5.1 Vp-p...
6-5. IC PIN FUNCTION DESCRIPTION • MAIN BOARD IC501 MN1884820S4G (XR-4750RDS), MN1886426S4H (XR-C450RDS) (SYSTEM CONTROLLER) Pin No. Pin Name Function TUNMUT Tuner muting control pin At muting: “H” AMPON Power amp power supply control pin Illumination power supply control pin ILLON At PW SEL on: ACC on: “H”...
Page 23
– A/D reference voltage input pin AVSS – – BUSON BUS ON control signai output pin (for SONY BUS) (C450RDS only) SYSRST System reset signal output pin (C450RDS only) SEKOUT SEEK control signal output pin TUNON Tuner power supply control pin...
SECTION 7 EXPLODED VIEWS NOTE: • -XX and -X mean standardized parts, so they • Items marked “*” are not stocked since they • Abbreviation may have some difference from the original are seldom required for routine service. Some G: German one.
SECTION 8 ELECTRICAL PARTS LIST NOTE: • Items marked “*” are not stocked since they • Abbreviation • Due to standardization, replacements in the are seldom required for routine service. G: German parts list may be different from the parts speci- Some delay should be anticipated when order- fied in the diagrams or the components used on the set.
Page 33
MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark R102 1-216-085-00 METAL CHIP 1/10W R505 1-216-049-00 METAL CHIP 1/10W R103 1-216-061-00 METAL CHIP 3.3K 1/10W R506 1-216-109-00 METAL CHIP 330K 1/10W R104 1-216-190-00 METAL CHIP 1/8W R507 1-216-198-00 METAL CHIP 1/8W...
Page 34
MAIN POWER Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark R583 1-216-166-00 METAL CHIP 1/8W < VIBRATOR > R584 1-216-238-00 METAL CHIP 1/8W R585 1-216-097-00 METAL CHIP 100K 1/10W 1-567-848-11 VIBRATOR, CRYSTAL (7.2MHz) R599 1-216-295-00 CONDUCTOR, CHIP (2012) 1-579-242-41 VIBRATOR, CRYSTAL (4.332MHz) R601...
Page 35
POWER Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 3-859-488-21 MANUAL, INSTRUCTION, INSTALL R803 1-216-049-00 METAL CHIP 1/10W (FRENCH, GERMAN, DUTCH, ITALIAN) R804 1-216-049-00 METAL CHIP 1/10W (4750RDS: AEP, G) R811 1-216-296-00 CONDUCTOR, CHIP (3216) X-3373-412-1 CASE (PANNEL) ASSY (for FRONT PANEL) ************************************************************ R812 1-216-296-00 CONDUCTOR, CHIP...
Page 36
XR-4750RDS/C450RDS AEP Model UK Model SERVICE MANUAL Ver 1.1 2001.06 SUPPLEMENT-1 File this supplement with the service manual. Subject: MAIN Board Modification (SPM-01012) In this set, following board has been changed in the midway of production. NEW/FORMER TYPE DISCRIMINATION – MAIN Board (Component Side) –...
Page 37
XR-4750RDS/C450RDS DIAGRAMS 2-1. NOTE FOR PRINTED WIRING BOARD AND SCHEMATIC DIAGRAMS Note on Printed Wiring Board: Note on Schematic Diagram: • X : parts extracted from the component side. • All capacitors are in µF unless otherwise noted. pF: µµF •...
Page 38
• Semiconductor Location (C450RDS) Ref. No. Location (C450RDS) CN701 CNJ150 BUS CONTROL IN BUS AUDIO LINE OUT (FOR SONY BUS) REAR G-14 (ORIGINAL SERVICE MANUAL Page 24) (ORIGINAL SERVICE MANUAL Page 24) D150 POWER BOARD POWER BOARD D151 CN803 CN802...
Page 39
XR-4750RDS/C450RDS 2-3. SCHEMATIC DIAGRAM – MAIN Board (1/3) – (C450RDS) FM/AM TUNER UNIT CNJ150 BUS AUDIO IN LINE OUT REAR C124 R118 R151 C151 C153 25V 3.3k 4.7k 0.47 0.022 R119 C123 C122 C222 C103 R101 C102 C152 100p 100p...
Page 42
XR-4750RDS/C450RDS MAIN 3. ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • Items marked “*” are not stocked since they When indicating parts by reference number, please include the board. parts list may be different from the parts speci- are seldom required for routine service.
Page 44
XR-4750RDS/C450RDS MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark D706 8-719-422-64 DIODE MA8062-M (C450RDS) JC59 1-216-296-00 CONDUCTOR, CHIP JC60 1-216-296-00 CONDUCTOR, CHIP < IC > JC62 1-216-296-00 CONDUCTOR, CHIP 8-759-448-88 IC TB2114F (EL) JC63 1-216-296-00 CONDUCTOR, CHIP...
Page 45
XR-4750RDS/C450RDS MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark 1-216-017-00 METAL CHIP 1/10W R365 1-216-065-00 METAL CHIP 4.7K 1/10W R403 1-216-077-00 METAL CHIP 1/10W 1-216-077-00 METAL CHIP 1/10W 1-216-075-00 METAL CHIP 1/10W R404 1-216-081-00 METAL CHIP...
Page 46
XR-4750RDS/C450RDS MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark R574 1-216-097-00 METAL CHIP 100K 1/10W X501 1-579-125-11 VIBRATOR, CERAMIC (8MHz) (4750RDS) X502 1-567-098-41 VIBRATOR, CRYSTAL (32.768kHz) R582 1-216-198-00 METAL CHIP 1/8W R583 1-216-166-00 METAL CHIP...
Page 47
XR-4750RDS/C450RDS REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2001.06...