6.7 Connection of DECT Portable Stations — KX-TDA30
6.7.2
Procedure Overview
When connecting the wireless system, use extreme care to conduct a site survey. Site surveys
can be conducted using the KX-TCA255 or KX-TD7590 PS. Inadvertent site survey can result
in poor service area, frequent noise, and disconnection of calls.
1. Investigate the installation site
Refer to "6.7.3 Site Planning".
a.
Obtain the map of the CS installation site.
b.
Consider the service area demanded by the user on the map.
c.
Plan the locations of each CS, taking account of distance, building materials and etc.
2. Prepare for site survey
Refer to "6.7.4 Before Site Survey".
a.
Check and assign the CS ID number to the PS.
b.
Assign a channel number to each CS by setting the DIP switches on the back of the
CS.
c.
Supply electricity to each CS using an AC adaptor or a battery box.
d.
Install each CS temporarily as planned.
Notes
•
•
3. Conduct the site survey
Refer to "6.7.5 Site Survey Using the KX-TCA255/KX-TD7590".
a.
Test the radio signal strength using the PS.
Confirm that the radio signal strength level is "12" near the CS.
Using the KX-TCA255
Using the KX-TD7590
b.
By walking away from the CS with the PS, check the radio signal strength. The radio
signal strength weakens as you walk away from the CS.
c.
Map the CS coverage area at radio signal strength levels "3" and "8".
d.
Make sure that adjacent CS coverage areas overlap where the radio signal strength
level is "8" by at least 5 m.
324
Installation Manual
Install at least 2 m above the floor.
Keep the antennas in the upright position.
Press 1, 9, and POWER
for more than 2 seconds.
Press 1, 9, and POWER
for more than 5 seconds.
Display example:
To survey
specific channel
RADIO STRENGTH
Channel No.
<<< MEASURING >>>
0 to 9
To survey
specific channel
Display example:
Channel No.
RADIO STRENGTH
<<< MEASURING >>>
0 to 9
RADIO STRENGTH
CH0 SLOT:06 SYNC
L:12
0000/0100
CS-ID:9005301234
CH0 SLOT:06 SYNC
L:12 0000/0100
CS-ID:9005301234