Table of Contents
Advertisement
LOWR
3. Install the drive shaft 5 into the lower
case. Then install the pinion 6, washer
7 and pinion nut 8, and then tighten the
nut 8 to the specified torque.
5
8
NOTE:
Install the drive shaft by lifting it up slightly,
then aligning it with the pinion and the spline
of the drive shaft.
Drive shaft holder 6 9:
90890-06520
Pinion nut holder 0:
90890-06715
Pinion nut:
142 N·m (14.2 kgf·m, 104.7 ft·lb)
6-49
Lower unit
6
7
6S360107
9
0
6F660315
4. Install the drive shaft housing q, and
then tighten the drive shaft housing bolt
w.
q
NOTE:
Apply LOCTITE 572 to the drive shaft hous-
ing bolts before installation.
Drive shaft housing bolt w:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
Installing the propeller shaft housing
1. Set the shift rod joint and dog clutch 1 to
the neutral position.
2. Apply grease to a new O-ring, and then
install it onto the propeller shaft housing.
3. Install the washer 2 and propeller shaft
assembly 3 into the lower case.
1
NOTE:
Face the shift plunger connect part to
upward.
w
6S360108
3
2
6S360420
6S35H11
- Quick Links:
- Specification
Hide quick links:
Advertisement
Chapters
Table of Contents
