Connecting A Terminal Or Pc To The Router's Console Port (Optional) - Cisco 836 Hardware Installation Manual

Hide thumbs Also See for 836:

Table of Contents

Chapter 2

Installation

Step 1

Step 2

Step 3

Connecting a Terminal or PC to the Router's Console Port

(Optional)

Note

78-15281-02

Perform the following steps to connect the ADSL line to a cable wall jack:

Connect the RJ-11 end of the ADSL over ISDN cable to the ADSLoISDN port on

the router.

Connect the other RJ-11 end of the ADSL over ISDN cable to the splitter's local

ADSL connector port.

Connect the unshielded Category 5 cable from the splitter's outside ADSL port to

a wall jack.

You can connect either a terminal or a PC to the router's console port. You can use

the terminal or PC for configuring the software via the CLI or for troubleshooting.

To connect a terminal or PC, follow the steps given after

shows a Cisco 836 router, but it also applies to the Cisco SOHO 96 router. The

connection procedure applies to both the Cisco 836 router and the Cisco SOHO 96

router.)

Unless you are an experienced network administrator, it is recommended that you

use the Cisco Router Web Setup software to configure the router. Use of this

software is described in the

Router" section on page

Cisco 836 Router and SOHO 96 Router Hardware Installation Guide

"Using Cisco Router Web Setup to Configure the

2-47.

Installing the Router

Figure

2-3.

(Figure 2-3

2-37

Table of Contents

Soho 96