Advertisement
Connecting Cisco T3 and E3 Service Modules to the Network
SPA EEPROM data for subslot 2/0:
Connecting Cisco SM-X-1T3/E3 Service Modules to the Network
To connect a Cisco SM-X-1T3/E3 enhanced service module to the network, use a 75-ohm 728-A coaxial
cable to connect the BNC connector on the service module to a networking device (see
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Warning
No user-serviceable parts inside. Do not open. Statement 1073
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning
Read the installation instructions before connecting the system to the power source. Statement 1004
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
OL-27149-01
EEPROM version
Compatible Type
Controller Type
Hardware Revision
PCB Part Number
Top Assy. Part Number
Board Revision
Deviation Number
Fab Version
PCB Serial Number
Asset ID
Product Identifier (PID) : SM-X-1T3/E3
Version Identifier (VID) : V01
CLEI Code
Base MAC Address
MAC Address block size
Manufacturing Test Data
Environment Monitor Data : 40 0B E3 43 00 0A
Platform features
Connecting Cisco SM-X-1T3/E3 Service Modules to the Network
: 4
: 0xFF
: 1909
: 1.0
: 73-14154-02
: 800-36532-01
: 06
: 123598
: 02
: FOC15495HU1
: REV 2F
: TBD
: C4 0A CB 56 00 99
: 3
: 00 00 00 00 00 00 00 00
: 02 01 01 0A 00 00 00 00
01 01 00
Connecting Cisco T3 and E3 Service Modules to the Network
Figure
2).
7
Hide quick links:
Advertisement
