Copy The Startup Configuration To The Running Configuration; View The Configuration; Clear And Remove Configuration Settings - Cisco ASA Series Getting Started
Hide thumbs
Also See for Cisco ASA Series:
- Cli configuration manual (2164 pages) ,
- Configuration manual (429 pages) ,
- Mount and connect (12 pages)
Table of Contents
Advertisement
Copy the Startup Configuration to the Running Configuration
• For contexts that are not saved because of bad sectors in the flash memory, the following message
Copy the Startup Configuration to the Running Configuration
Use one of the following commands to copy a new startup configuration to the running configuration:
• copy startup-config running-config
• reload
• clear configure all and then copy startup-config running-config
View the Configuration
The following commands let you view the running and startup configurations:
• show running-config
• show running-config command
• show startup-config
Clear and Remove Configuration Settings
To erase settings, enter one of the following commands:
• clear configure configurationcommand [level2configurationcommand]
CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.5
26
context 'a' , context 'b' , context 'c' .
appears:
The context 'context a' could not be saved due to Unknown errors
Merges the startup configuration with the running configuration. A merge adds any new commands
from the new configuration to the running configuration. If the configurations are the same, no changes
occur. If commands conflict or if commands affect the running of the context, then the effect of the
merge depends on the command. You might get errors, or you might have unexpected results.
Reloads the ASA, which loads the startup configuration and discards the running configuration.
Loads the startup configuration and discards the running configuration without requiring a reload.
Views the running configuration.
Views the running configuration of a specific command.
Views the startup configuration.
Clears all the configuration for a specified command. If you only want to clear the configuration for a
specific version of the command, you can enter a value for level2configurationcommand.
Getting Started
Advertisement
Table of Contents
