Cisco Nexus 3000 Series Configuration Manual page 293
Nx-os unicast routing configuration guide,
nx-os release 5.0(3)u1(1)
Hide thumbs
Also See for Nexus 3000 Series:
- Command reference manual (356 pages) ,
- Configuration manual (182 pages) ,
- Installation manual (112 pages)
Table of Contents
Advertisement
Chapter 13
Configuring VRRP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
Configuring VRRP
This section includes the following topics:
•
•
•
•
•
•
•
If you are familiar with the Cisco IOS CLI, be aware that the Cisco NX-OS commands for this feature
Note
might differ from the Cisco IOS commands that you would use.
Enabling the VRRP Feature
You must globally enable the VRRP feature before you can configure and enable any VRRP groups.
To enable the VRRP feature, use the following command in global configuration mode:
Command
feature vrrp
Example:
switch(config)# feature vrrp
To disable the VRRP feature and remove all associated configuration, use the following command in
global configuration mode:
Command
no feature vrrp
Example:
switch(config)# no feature vrrp
Enabling the VRRP Feature, page 13-7
Configuring VRRP Groups, page 13-8
Configuring VRRP Priority, page 13-9
Configuring VRRP Authentication, page 13-11
Configuring Time Intervals for Advertisement Packets, page 13-12
Disabling Preemption, page 13-14
Configuring VRRP Interface State Tracking, page 13-15
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
Purpose
Enables VRRP.
Purpose
Disables the VRRP feature.
Configuring VRRP
13-7
Hide quick links:
Advertisement
Table of Contents
