Table of Contents
Advertisement
How to Install, Connect, or Replace the EVM-IPVS-16A Network Module
Connecting the EVM-IPVS-16A Network Module to the Network
This section describes how to connect the EVM-IPVS-16A network module to devices in the video
surveillance network.
Note
If an installation technician has already connected the EVM-IPVS-16A to the devices in your network,
then do not perform this task. Instead, proceed directly to the software configuration for your
EVM-IPVS-16A network module. See the Cisco Analog Video Gateway 1.0 Installation and Upgrade
Guide at:
http://www.cisco.com/en/US/docs/video/cavg/cavginstall/cavginstall.html
Prerequisites
•
•
Steps
To connect the EVM-IPVS-16A network module to the network, follow these steps:
Take the DB-37 end of the provided DB-37 to BNC video breakout cable, and connect it to the VIDEO
Step 1
connector on the EVM-IPVS-16A network module.
Connecting Cisco Analog Video Gateway Network Modules to the Network
8
Install the EVM-IPVS-16A network module in the router chassis. See the Installing Cisco Network
Modules in Cisco Access Routers guide at:
http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/InstNe
tM.html
Wire the provided terminal block connectors. See the
section on page
6.
Connecting Cisco Analog Video Gateway Network Modules to the Network
"Wiring the Terminal Block Connectors"
Advertisement
Table of Contents
