Table of Contents
Advertisement
Removing and Installing CompactFlash Memory
Cards
This document describes installing and replacing CompactFlash memory cards in Cisco IAD2801 series
integrated access devices. It contains the following sections:
•
•
•
Preventing Electrostatic Discharge Damage
CompactFlash memory cards are sensitive to electrostatic discharge (ESD) damage, which can occur
when electronic cards or components are handled improperly, results in complete or intermittent failures.
To prevent ESD damage, follow these guidelines:
•
•
•
•
•
Caution
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
between 1 and 10 megohms (Mohms).
OL-12433-01
Preventing Electrostatic Discharge Damage, page C-1
Removing a CompactFlash Memory Card, page C-2
Installing a CompactFlash Memory Card, page C-2
Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
Connect the equipment end of the strap to an unfinished chassis surface.
Place a removed CompactFlash memory card on an antistatic surface or in a static shielding bag. If
the card will be returned to the factory, immediately place it in a static shielding bag.
Avoid contact between the card and clothing. The wrist strap protects the card from ESD voltages
on the body only; ESD voltages on clothing can still cause damage.
Do not remove the wrist strap until the installation is complete.
Cisco IAD2801 Series Integrated Access Devices Hardware Installation Guide
A P P E N D I X
C
C-1
Advertisement
Table of Contents
Troubleshooting
