Verifying Bgp Configuration In Destination Context; Disabling Bulk Statistics Collection On A Standby System; Verifying The Primary And Backup Configuration - Cisco ASR 5500 System Administration Manual
Hide thumbs
Also See for ASR 5500:
- Administration manual (410 pages) ,
- Installation manual (192 pages) ,
- Installation procedure overview (6 pages)
Table of Contents
Advertisement
Interchassis Session Recovery
Verifying BGP Configuration in Destination Context
Verify your BGP configuration by entering the show srp monitor bgp command (Exec Mode).
Disabling Bulk Statistics Collection on a Standby System
You can disable the collection of bulk statistics from a system when it is in the standby mode of operation.
Important
Use the following example to disable the bulk statistics collection on a standby system.
configure
bulkstat mode
Repeat this procedure for both systems.
Verifying the Primary and Backup Configuration
This section describes how to compare the ICSR configuration on the primary and backup systems.
Step 1
Enter the show configuration srp command on each system (Exec mode).
Step 2
Verify that both chassis have the same SRP configuration information.
The output looks similar to following:
config
context source
interface haservice loopback
ip address 172.17.1.1 255.255.255.255 srp-activate
#exit
radius attribute nas-ip-address address 172.17.1.1
radius server 192.168.83.2 encrypted key 01abd002c82b4a2c port 1812
radius accounting server 192.168.83.2 encrypted key 01abd002c82b4a2c port 1813
ha-service ha-pdsn
mn-ha-spi spi-number 256
fa-ha-spi remote-address 192.168.82.0/24 spi-number 256 encrypted secret 1088bdd6817f64df
bind address 172.17.1.1
#exit
#exit
context destination
ip pool dynamic 172.18.0.0 255.255.0.0 public 0 srp-activate
ip pool static 172.19.0.0 255.255.240.0 static srp-activate
#exit
context srp
service-redundancy-protocol
When this feature is enabled and a system transitions to standby state, any pending accumulated statistical
data is transferred at the first opportunity. After that no additional statistics gathering takes place until the
system comes out of standby state.
no gather-on-standby
end
encrypted secret 6c93f7960b726b6f6c93f7960b726b6f hash-algorithm md5
Disabling Bulk Statistics Collection on a Standby System
ASR 5500 System Administration Guide, StarOS Release 21.5
285
Advertisement
Table of Contents
Troubleshooting
