Getting Help - Cisco Catalyst 3550 series Software Configuration Manual
Multilayer switch
Hide thumbs
Also See for Catalyst 3550 series:
- Reference manual (58 pages) ,
- Datasheet (21 pages) ,
- Manual (19 pages)
Table of Contents
Advertisement
Chapter 2
Using the Command-Line Interface
Table 2-1
Command Mode Summary (continued)
Mode
Access Method
Interface
While in global
configuration
configuration mode,
enter the interface
command (with a
specific interface).
Line configuration
While in global
configuration mode,
specify a line with
the line vty or line
console command.
Getting Help
You can enter a question mark (?) at the system prompt to display a list of commands available for each
command mode. You can also obtain a list of associated keywords and arguments for any command, as
shown in
Table 2-2
Help Summary
Command
help
abbreviated-command-entry?
abbreviated-command-entry<Tab>
?
78-11194-09
Prompt
Switch(config-if)#
Switch(config-line)#
Table
2-2.
Purpose
Obtain a brief description of the help system in any command mode.
Obtain a list of commands that begin with a particular character string.
For example:
Switch# di?
dir
disable
disconnect
Complete a partial command name.
For example:
Switch# sh conf<tab>
Switch# show configuration
List all commands available for a particular command mode.
For example:
Switch> ?
Exit Method
To exit to global
configuration mode,
enter exit.
To return to
privileged EXEC
mode, press Ctrl-Z or
enter end.
To exit to global
configuration mode,
enter exit.
To return to
privileged EXEC
mode, press Ctrl-Z or
enter end.
Catalyst 3550 Multilayer Switch Software Configuration Guide
Getting Help
About This Mode
Use this mode to configure
parameters for the Ethernet
interfaces.
To configure multiple
interfaces with the same
parameters, see the
"Configuring a Range of
Interfaces" section on
page
10-8.
Use this mode to configure
parameters for the terminal
line.
2-3
Advertisement
Table of Contents
Troubleshooting
