Configuring Sparse Mode With Auto-Rp - Cisco Catalyst 3650 Configuration Manual
Ip multicast routing
Hide thumbs
Also See for Catalyst 3650:
- Hardware installation manual (118 pages) ,
- Manual (120 pages) ,
- Command reference manual (90 pages)
Table of Contents
Advertisement
Configuring Sparse Mode with Auto-RP
Configuring Sparse Mode with Auto-RP
Before You Begin
• An interface configured in sparse-dense mode is treated in either sparse mode or dense mode of operation,
• All access lists that are needed when Auto-RP is configured should be configured prior to beginning the
• If a group has no known RP and the interface is configured to be sparse-dense mode, the interface
Note
• When configuring Auto-RP, you must either configure the Auto-RP listener feature (Step 5) and
• When you configure sparse-dense mode, dense mode failover may result in a network dense-mode
Follow this procedure to configure auto-rendezvous point (Auto-RP). Auto-RP can also be optionally used
with anycast RP.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3650 Switches)
146
depending on the mode in which the multicast group operates. You must decide how to configure your
interfaces.
configuration task.
is treated as if it were in dense mode, and data is flooded over the interface. To avoid this data
flooding, configure the Auto-RP listener and then configure the interface as sparse mode.
specify sparse mode (Step 7) or specify sparse-dense mode (Step 8) .
flood. To avoid this condition, use PIM sparse mode with the Auto-RP listener feature.
Configuring PIM
OL-29890-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
