Fault
Food remnants on the
utensils.
Detergent residue
Reason
Utensils placed too closely
together, utensils basket
overfilled.
Spray arm rotation obstructed.
Spray arm nozzles are blocked.
Filters 1J dirty.
Filters 1J inserted incorrectly
and/or not engaged.
Rinse programme too weak.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Tall narrow receptacles in corner
areas are not rinsed adequately.
Top basket 1* on right and left
not set to same height.
Detergent dispenser cover 1j
blocked by utensils and therefore
does not open fully.
Detergent dispenser cover 1j
blocked by the tablet.
Tablets used in the quick or short
programme.
Dissolving time of the detergent
is not reached in the selected
short programme.
Washing effect and dissolving
performance are reduced after a
prolonged storage time or
detergent is very lumpy.
Fault, what to do? aus
Solution
Arrange utensils with adequate clearance
between them ensuring that the spray jets
can reach the surface of the utensils.
Prevent contact points.
Arrange utensils so that the spray arm can
rotate without obstruction.
Clean the spray arm
nozzles.~ "Cleaning and maintenance"
on page 28
Clean filters. ~ "Cleaning and
maintenance" on page 28
Insert and engage filters correctly.
Select a more intensive rinse programme.
Do not prerinse utensils.Remove only
large food remnants.
Do not place tall narrow receptacles too
obliquely and do not place in the corner
area.
Set top basket to same height using side
levers.
Utensils must not be placed above the
tablet collecting tray 1:.These may
block the lid of the detergent dispenser
and prevent it from opening fully.
~ "Upper basket" on page 15
Do not place utensils or fragrance
dispenser in the tablet collecting tray.
Tablet must be inserted flat and not
upright.
Dissolving time of tablets too long for a
quick or short programme.
Use a detergent powder or select a more
intensive programme.
Change detergent.
35