Suggested Next Steps; Troubleshooting - Cisco WAP125 Quick Start Manual
Wireless-ac/n dual band
desktop access point with poe
Hide thumbs
Also See for WAP125:
- Administrator's manual (114 pages) ,
- Manual (10 pages) ,
- Quick start manual (14 pages)
Table of Contents
Advertisement
Follow the Setup Wizard instructions to finish the WAP device
S
7
TEP
installation.
We strongly recommend that you use the Setup Wizard for the first
installation. For more advanced configurations, see the
Administration Guide. A link to the Administration Guide is found in
Where to Go from
Congratulations, you can now start using your Cisco WAP125.
Suggested Next Steps
7
In case of an error while installing, try the troubleshooting procedures
described in this section.
Troubleshooting
If you cannot display the configuration utility, you can test the ability of the
computer to communicate with the Cisco WAP125 by using ping. To use
ping on a computer running Windows:
Verify that the Cisco WAP125 is powered on and the lights indicate
S
1
TEP
the appropriate links.
Locate the Cisco WAP125's IP address. While there are different
S
2
TEP
ways to locate the IP address, this procedure uses Cisco FindIT.
a.
If you have previously downloaded Cisco FindIT, open Internet
Explorer and launch Cisco FindIT. For more information on
downloading Cisco FindIT, see www.cisco.com/go/findit.
b. In the Cisco FindIT display, place your mouse over the Cisco
WAP125's name. The Cisco WAP125's IP address is displayed
along with other device information.
Open a command window by choosing Start > Run and enter
S
3
TEP
cmd.
At the command window prompt, enter ping and the Cisco
S
4
TEP
WAP125's IP address. In this example, we pinged 192.168.1.245.
If successful, you should get a reply similar to the following:
Pinging 192.168.1.245 with 32 bytes of data:
Reply from 192.168.1.245: bytes=32 time<1ms TTL=128
Cisco WAP125 Quick Start Guide
Here.
7
- Quick Links:
- Default Settings
Hide quick links:
Advertisement
Table of Contents
