Install The Optional Cable Management Brackets - Cisco Firepower 2120 Hardware Installation Manual
Firepower 2100 series
Hide thumbs
Also See for Firepower 2120:
- Getting started manual (104 pages) ,
- Hardware installation manual (84 pages) ,
- Getting started (42 pages)
Table of Contents
Advertisement
Maintenance and Upgrades
Statement 1073—No User-Serviceable Parts
Warning
No user-serviceable parts inside. Do not open.
Step 1
Have the fan tray ready for immediate insertion and near the appliance so that you can reinstall the fan tray within 30
seconds.
Step 2
To remove a fan tray, face the rear of the chassis, and loosen the two captive screws on the fan tray.
Step 3
Pull the fan tray out of the chassis.
Figure 29: Removing the Fan Tray
Step 4
To replace a fan tray, hold the fan tray in front of the fan slot.
Step 5
Push the fan tray into the chassis until it is properly seated.
If the system is powered on, listen for the fans. You should immediately hear the fans operating. If you do not hear the
fans, make sure the fan tray is inserted completely into the chassis and the faceplate is flush with the outside surface of
the chassis.
Step 6
Verify that the fan is operational by checking the fan tray LED. See
the fan LEDs.
Install the Optional Cable Management Brackets
You can install the optional cable management bracket on all models of the 2100 series. The optional cable
management bracket kit comes with 2 cable management brackets and four 8-32 x 0.375" screws.
Take note of the following warnings:
Install the Optional Cable Management Brackets
Front Panel LEDs, on page 9
Cisco Firepower 2100 Series Hardware Installation Guide
for a description of
55
Hide quick links:
Advertisement
Table of Contents
