Installing The Chassis In The Rack - Cisco Catalyst 4948E Installing Manual

Hide thumbs Also See for Catalyst 4948E:

Table of Contents

Chapter 3

Installing the Switch

Figure 3-1

Installing the Chassis in the Rack

To install the chassis in the rack, follow these steps:

Step 1

Have one person carefully lift and position the chassis in front of the rack.

Position the chassis in the rack until the rack-mount bracket ears are in contact with the rack.

Step 2

Tip

Use a tape measure or a level to ensure that the chassis is installed level in the rack.

Step 3

Adjust the chassis up or down in the rack until two screw holes in each rack-mount bracket ear are

aligned with corresponding mounting holes in the equipment rack post. Place a level on top of the chassis

and verify that the chassis is not tilted in the equipment rack.

While one person holds the chassis in place, secure the chassis to the rack with the four 10-32 x 3/4-inch

Step 4

or the four 12-24 x 3/4-inch Phillips-head machine screws (two on each side) that are supplied in the

accessory kit.

OL-21561-02

Installing the Rack-Mount Brackets

M4 screws (4 screws per bracket)

Rack-mount bracket

Catalyst 4948E and Catalyst 4948E-F Switch Installation Guide

Rack-Mounting the Chassis

3-7

Table of Contents

Show Quick Links

Table of Contents