Appendix; Using Optical Splitters With 10 Gbe Links; Introduction; Supported Configurations - Cisco SCE 8000 Installation And Configuration Manual
10 gbe
Hide thumbs
Also See for SCE 8000:
- Configuration manual (262 pages) ,
- Installation and configuration manual (176 pages) ,
- Installation manual (51 pages)
Table of Contents
Advertisement
Using Optical Splitters with 10 GBE Links
Revised: August 26, 2014
Introduction
When designing a deployment with the Cisco SCE 8000, it is important to keep in mind certain
characteristics of the 10 GBE link that affect the configuration of optical splitters and SPAN ports:
•
•
•
This chapter contains the following sections:
•
•
Supported Configurations
With regard to the 10 GBE characteristics described in the introduction, the following configurations are
supported in the 10 GBE environment as shown in
10 GBE does not support autonegotiation (unlike regular GBE). The fixed 10 GBE configuration is
as follows:
duplex = full
–
speed = 10 GBE
–
The 10 GBE port is UP once it detects light (and correct sync pattern) in the RX input.
A Switch or Router port will not transmit data unless it is UP (that is, it detects a good signal on the
RX input).
Supported Configurations, page A-1
Unsupported Configuration, page A-2
A P P E N D I X
Figure A-1
and
Figure
Cisco SCE8000 GBE Installation and Configuration Guide
A
A-2.
A-1
Advertisement
Table of Contents
Troubleshooting
