Using Bluetooth™ Components; Pairing The Bluetooth™ Receiver And Your Bluetooth Component; Playback Of The Bluetooth™ Component - Yamaha RX-V1900 Owner's Manual
Hide thumbs
Also See for RX-V1900:
- Owner's manual (751 pages) ,
- Service manual (198 pages) ,
- Owner's manual (146 pages)
Table of Contents
Advertisement
Available languages
Available languages
You can connect a Yamaha Bluetooth receiver (such as YBA-10, sold separately) to the DOCK terminal of this unit and
enjoy the music contents stored in your Bluetooth component (such as a portable music player) without wiring between
this unit and the Bluetooth component. You need to perform "pairing" the connected Bluetooth wireless audio receiver
and your Bluetooth component in advance.
Note
This unit supports A2DP (Advanced Audio Distribution Profile) Bluetooth profile.
Pairing the Bluetooth™ receiver
and your Bluetooth component
Pairing must be performed when using a Bluetooth
component with the Bluetooth receiver connected to this
unit for the first time or if the pairing data has been
deleted. "Pairing" refers to the operation of registering a
Bluetooth component for Bluetooth communications.
y
• You need the pairing operation only for the first time when you
use the Bluetooth component with the Bluetooth receiver.
• Pairing requires operations on this unit and on the other
component with which Bluetooth communications are to be
established. If necessary, refer to the other component's
operating instructions.
There are two pairing methods: pairing by using "START
PAIRING" in "SET MENU" and quick pairing.
■ Pairing by using "SET MENU"
Use this feature to perform pairing with the OSD. For
details, see "START PAIRING" (page 75).
■ Quick pairing
To ensure security, a time limit of 8 minutes is set for the
pairing operation. You are recommended to read and fully
understand all the instructions before starting.
1
Rotate the CINPUT selector (or set the
operation mode selector to ESOURCE and
then press 3DOCK) to select "DOCK" as
the input source.
2
Turn on your Bluetooth component and then
set the Bluetooth component to the paring
mode.
For details about how to operate the Bluetooth
component, refer to the manual for it.
Using Bluetooth™ components
3
Press and hold FENTER (or 8ENTER)
until "Searching" appears in the front panel
display.
While the Bluetooth receiver is in the pairing mode,
DOCK indicator flashes in the front panel display.
y
To cancel the pairing, press FENTER (or 8ENTER) again.
4
Check that the Bluetooth component detects
the Bluetooth receiver.
If the Bluetooth component detects the Bluetooth
receiver, "YBA-10 YAMAHA" (example) appears in
the Bluetooth device list.
5
Select the Bluetooth receiver in the
Bluetooth device list and then enter the pass
key "0000" on the Bluetooth component.
When the pairing procedure is successful, "BT
connected" appears in the front panel display.
Note
The Yamaha Bluetooth receiver can be paired with up to eight
Bluetooth components. When pairing is conducted successfully
with a ninth component and the pairing data is registered, the
pairing data for the least recently used other component is cleared.
Playback of the Bluetooth™ component
1
Rotate the CINPUT selector (or set the
operation mode selector to ESOURCE and
then press 3DOCK) to select "DOCK" as
the input source.
2
Start playback of your Bluetooth component.
When the connected Bluetooth receiver detects the
Bluetooth component, "BT connected" appears in the
front panel display.
y
• When you press 8ENTER on the remote control, the
connected Bluetooth receiver searches and connect to the last
connected Bluetooth component. If the Bluetooth receiver
cannot find the Bluetooth component, "Not found" appears in
the front panel display.
• To disconnect the Bluetooth receiver from the Bluetooth
component, press 8ENTER.
55
En
Advertisement
Chapters
Table of Contents
