Periodic maintenance and adjustment
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
1
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
2
higher.
Make sure that no foreign mate-
rial enters the crankcase.
3
11. Start the engine, and then let it idle
for several minutes while checking
4
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
5
12. Turn the engine off, and then
check the oil level and correct it if
necessary.
6
13. Reset the oil change indicator.
(See page 4-6.)
7
TIP
If the engine oil is changed before the
oil change indicator comes on (i.e. be-
8
fore the periodic oil change interval has
been reached), the indicator must be
reset after the oil change for the next
9
periodic oil change to be indicated at
the correct time.
10
11
12
13
14
Coolant
The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on the center-
stand.
TIP
The coolant level must be checked
on a cold engine since the level
varies with engine temperature.
Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Check the coolant level through
the check window.
TIP
The coolant should be between the
minimum and maximum level marks.
1
1. Coolant level check window
2. Maximum level mark
3. Minimum level mark
3. If the coolant is at or below the
minimum level mark, remove the
left floorboard mat by pulling it up.
7-13
EAU20071
EAU52024
2
3