Exporting Programmable Scanning Data To The Receiver - Sony ICF-SC1PC Operating Instructions Manual

Scanning receiver controller

Hide thumbs Also See for ICF-SC1PC:

Table of Contents

Note

You cannot exclude a band if it is the only target band.

To start scanning again manually during scan

pause

Click + or –.

Scanning will restart in ascending direction if you click +,

and in descending direction if you click –.

To change scanning direction during scanning

Click + or –.

Scanning will change to the ascending direction if you

click +, and to the descending direction if you click –.

To stop scanning

Click [SCAN STOP].

Scanning will stop at the present frequency.

Exporting Programmable Scanning

data to the receiver

You can export Programmable Scanning data on the

controller to the receiver. This will overwrite the present

Preset L and Preset U frequencies in the receiver.

Note that once the data is overwritten in the receiver, you

cannot retrieve the old data.

Select [Send Program Data To Receiver] from the

[Options] menu.

The Send Program Data To Receiver dialog will

appear.

Select the options to your choice and click [OK].

Type in the lower and upper limit frequencies.

Select a detection mode from the pull-down menu.

Select a frequency step from the pull-down menu.

Click [OK] in the export confirmation dialog.

Table of Contents