Cr Encoder Strip And Its Guard Film - Brother DCPJ525W Service Manual
Hide thumbs
Also See for DCPJ525W:
- Basic user's manual (100 pages) ,
- Quick setup manual (32 pages) ,
- User manual (85 pages)
Table of Contents
Advertisement
9.13 CR Encoder Strip and its Guard Film
CR encoder strip
(1) At the left end of the CR frame, push the rear end of the encoder strip spring inwards,
unhook the left end of the CR encoder strip from the spring, and then unhook the right end
from the CR frame.
(2) Turn the CR encoder strip in the direction of the arrow shown below, align the rectangular
hole in the left end of the strip with the boss of the strip support and take the strip off.
Remove the encoder strip spring.
Note: Take care not to scratch or damage the encoder strip. If it is stained or damaged,
replace it.
Encoder strip spring
Lower cover
Strip support
CR frame
Assembling Note: Set the CR encoder strip so that the
motor side) and the mark
CR encoder strip
points upwards as shown above.
3-88
This should point up.
marked end is to the right (carriage
-
(3_078)
Confidential
- Quick Links:
- Service Manual
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
